F150online Forums - Search Results

 
Search: Posts Made By: chuck gibson
Showing results 1 to 25 of 66
Search took 0.03 seconds.
09-12-2017, 08:51 PM
Replies: 10
Views: 711
Posted By chuck gibson

While pulsing the reset button, will the milage...

While pulsing the reset button, will the milage readout actually say "Fuel Octal"?
09-11-2017, 09:18 PM
Replies: 10
Views: 711
Posted By chuck gibson

Gas Gauge not working...Sometimes

Hey Guys,
My gas gauge is occasionally not moving up at all. A couple of times I killed the truck and restarted it and it moved up just fine. Does anyone know of any wires or whatever to check out...
09-03-2017, 10:03 PM
Replies: 0
Views: 365
Posted By chuck gibson

Broken MFS connector (turn signal switch repair)

A wire tie has held this tight for ages... Hope this helps!
09-03-2017, 09:40 PM
Replies: 0
Views: 349
Posted By chuck gibson

2000 F-150 Flasher replacement tutorial

This is not my video but it is excellant. It is quick and to the point without giving you instructions such as "Don't use hair dryer while taking a shower". LOL.
Hope it helps!
...
09-03-2017, 09:37 PM
Replies: 10
Views: 475
Posted By chuck gibson

Up and running great! Thanks for your help!

Up and running great!
Thanks for your help!
09-03-2017, 09:26 PM
Replies: 4
Views: 407
Posted By chuck gibson

I appologize if I offended you. Due to physical...

I appologize if I offended you. Due to physical problems it is difficult for me to get under the dash so I spent the $20.00 on an aftermarket MFS and tried it. As I posted, it did not fix the problem...
09-01-2017, 10:18 PM
Replies: 4
Views: 407
Posted By chuck gibson

Since it was a cheap quick fix I replaced the...

Since it was a cheap quick fix I replaced the multifunction turnsignal switch... no luck. Where do I go from here?
08-31-2017, 09:37 PM
Replies: 10
Views: 475
Posted By chuck gibson

I received my new Motorcraft condenser today. It...

I received my new Motorcraft condenser today. It has a notice in it that the freon charge qty will be lower. The OE system called for 33oz. The new condenser calls for 1.85 lbs. or 29.6 oz.
Have any...
08-29-2017, 09:59 PM
Replies: 20
Views: 1,924
Posted By chuck gibson

Would this schematic also work on a 2000 F-150,...

Would this schematic also work on a 2000 F-150, 4.6 V8? I have the same problem...
08-27-2017, 11:41 AM
Replies: 10
Views: 475
Posted By chuck gibson

Tore it down and rebuilt it at 306,000 miles.

Tore it down and rebuilt it at 306,000 miles.
08-26-2017, 11:28 PM
Replies: 10
Views: 475
Posted By chuck gibson

No sir I didn't. I kind of thought that the...

No sir I didn't. I kind of thought that the oriface tube caught the debris. It was not totally clogged. I sure hope I don't have a problem....

I probley should have. I can't complain much. This...
08-26-2017, 10:31 PM
Replies: 10
Views: 475
Posted By chuck gibson

I have not flushed it. The way I understand it...

I have not flushed it. The way I understand it the path the freon takes is from the compressor > condenser > oriface tube > dryer. I am replacing all of those parts and pulling a vacuum on the...
08-26-2017, 02:32 PM
Replies: 10
Views: 475
Posted By chuck gibson

It was a pain but... Got it! Now my next question...

It was a pain but... Got it! Now my next question is, I pulled my oriface tube and it is loaded with crap. Is there a filter I can put on my compressor line to keep debris from going in it?
08-26-2017, 12:53 PM
Replies: 10
Views: 475
Posted By chuck gibson

A/C quick connect hose removal

On a 2000 F-150 4.6 I am in the process of replacing the A/C compressor, drier and oriface tube. I am stuck trying to remove the drier hose leading into the evaporator. I have a plastic release tool...
08-21-2017, 10:24 PM
Replies: 12
Views: 823
Posted By chuck gibson

I don't know if your truck has COP's but my 4.6...

I don't know if your truck has COP's but my 4.6 V8 does. I have seen one start messing up and run fine until it gets hot. Then it will start making the truck kind of miss. I always keep a new one in...
08-21-2017, 07:45 PM
Replies: 4
Views: 407
Posted By chuck gibson

Turn Signal problem

Hello Folks!
I have an 2000 F-150 4.6 V8 XLT that the turn signals have started acting crazy on. Sometimes they will blink a time or two and then they will stop. If I jack with the handle sometimes...
07-17-2017, 10:28 PM
Replies: 3
Views: 612
Posted By chuck gibson

Got it! #4 COP was not functioning right. I...

Got it! #4 COP was not functioning right. I played leap frog with a new COP and when I switched out #4, the truck started runnig great!
Thanks for your help!
07-14-2017, 05:11 PM
Replies: 3
Views: 612
Posted By chuck gibson

Cleaned the MAF, replaced the PCV (parts house I...

Cleaned the MAF, replaced the PCV (parts house I went to did not sell Motorcraft but it was cheap enough that I got one until I can get a Motorcraft). Replaced the PCV grommet as it was hard and...
07-13-2017, 07:15 PM
Replies: 3
Views: 612
Posted By chuck gibson

2000 4.6 rough idle and surging

My truck has began idling rough and seems sluggish during acceleration. It seems to run smooth when the cruise control is set running about 70-75 mph. Several times while sitting at idle the truck...
04-10-2016, 09:14 PM
Replies: 9
Views: 2,916
Posted By chuck gibson

By the way, This IS the same problem...

By the way, This IS the same problem DarkGreenCrew was having. Look at how he has the timing marks highlighted in two places on picture #11... If both colored links would have been lined up at the...
Forum: V8 Engines
04-10-2016, 09:08 PM
Replies: 23
Views: 23,214
Posted By chuck gibson

Caution!

CAUTION: A one piece crankshaft sprocket is reversable. Each side is marked with a dimple indicating where the colored link should fall. At least this is what common sense would tell you.... But,...
04-10-2016, 09:00 PM
Replies: 9
Views: 2,916
Posted By chuck gibson

Found the problem! A one piece crankshaft...

Found the problem! A one piece crankshaft sprocket is reversable. Each side is marked with a dimple indicating where the colored link should fall. At least this is what common sense would tell...
04-10-2016, 11:39 AM
Replies: 9
Views: 2,916
Posted By chuck gibson

Come on. I'm having the same problem. What was...

Come on. I'm having the same problem. What was the outcome?
03-29-2016, 08:38 PM
Replies: 3
Views: 4,095
Posted By chuck gibson

Success! You were spot on with the bolt sizes!...

Success! You were spot on with the bolt sizes! Good thing I stuck with this little chore because the oil pick up screen was 3/4 of the way clogged.

Mserenil, Thanks again!!!
Chuck
03-29-2016, 04:01 PM
Replies: 3
Views: 4,095
Posted By chuck gibson

Thank you much. It will be a few hours before I...

Thank you much. It will be a few hours before I can get back under it but now that I have heard this it sure picks up my spirits!
I will post my results.
Thanks again!
Chuck
Showing results 1 to 25 of 66
 


 
Forum Jump

Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.