Just ran across your screw conversion and all i have to say is kudos bro thats alot of hassel to put up with for the panels and not completely losing your cool with those guys

Hey I followed your 2006 screw project and now I'm Going to attempt the same thing but go the ford oem parts for the front end. I was wondering if you knew if all the raptor front panels would just bolt right up? Also what did you do to get the raptor front bumper to fit? Thanks!

I used the factory raptor ford gas door housing and filler setup, I bought the no gas cap filler neck from ford so it all fits right. I actually used my old support rods , just tweeked them a little to work.

Hey I've been following your Raptor conversion and was wondering what you did with the fuel door and is there an extension for the filler neck? Also did you make new bed panel reinforcement rods? (those 2 metal rods that hold the bed by the wheel well so it doesn't flex.)