wanted to say thank you for the TOTM vote! It's greatly appricaited!

Thank you so much for the TOTM vote!!

Will

Haha ya, the tip is a has a 4" inlet and the pipe from my muffler back is 4" so it wasn't too difficult

Ya man I had a local guy here in town do up the exhaust and its a flowmaster single chamber with a 8" tip that I got at his shop and we ran it out the back just like how it was stock

I can get them to you for $450

Thanks for your vote in TOTM!

Got about roughly.... 15,000 miles on them and they still have lots left.

Hey Scharpie, I gots some cash, sold the shaft, you up for some front and rear gear installation!

I like the lift, I haven't done much offroading though. I'd look through the lift before you go to install it, make sure every part is there. It sucks getting everything torn apart and finding out you need a bolt that you can't find anywhere. Also make sure you get the lower control arm bolts really tight because you can knock your alignment out of whack pretty easy if they arent. Not sure on the torque spec.

In my opinion, for a lift, Rize is bullet proof compared to other products. Remember I'm also just your regular Joe, but unlike others I truly abuse my turck to the max. The lift is best of most lift out there and as you said, you don't and probably won't off road so you will definitely be more that fine with it. The lift not only looks good but it's its worth every penny you put in it. You can use stock parts on the lift and don't worry about quicker wear and tear. One thing though if ya gonna go for the lift you have to add the cost of new and bigger tires and if you go with bigger tires you will have to re gear. Tire size 35's minimum, 37's maximum. Any other question you may have don't hesitate to ask, asking is best way to gain knowledge.
Take a look at how I hammer my truck, if you have a youtube account done forget to rate and or comment.
http://www.youtube.com/watch?v=WEolYaf2C6o