Keyless Entry Wiring for 99's (Help)
 

Ok,

Question for the collective regarding keyless entry install on 99’s….

As the 99’s do not have the connector prewired in the door for the keypad actuator, I need some help as to conneting the wires into the proper slots in the “white box” under the dash.

This is the last step for me to finish the install as all other componants are installed and ready to go.

FYI.. Running the wires through the flextubing into the cabin is a BlTCH!!, plain and simple. Two hours and a few &^^%$# thrown in.

Nevertheless, Any advise would be greatly appreciated.

The tip on the 9-pin connector swap out was a great idea. Got to practice my soldering skills (it had been awhile).

The wires are as follows:

Red
Black
Green
Brown
Yellow w/ black stripe
Yellow
Blue w/ yellow stripe
Blue



------------------
Brake Late, Dive Deep

Speedin Bob
'99 Red Lightning #2504 Built 6/17/99
NLOC # 438
13.98 @ 98 mph (Rookie Session)

Latest Mods:
Superchip (on order)
Keyless Entry
Retrax Bed Cover
2000 L Tiedowns over 99's
Super White Head and Fog lights
Wet Okole Seat Covers
Mobil One and FilterMag
Airaid w/ Autophysics filter retrofit
Clear Corners & Tails
Bugflector
Duraliner

back to the top....

Bob

The following threads originally talked about the mod with the wiring schematic.

I hope this helps
https://www.f150online.com/f150board...ML/004518.html http://www.scomm.net/~smithm/faq.phtml#K


------------------
Jim
jim@jimshaw.cc

Black 00, Swanson Chip, 4.10's, super whites, Airaid w/10" Big Mouth
chrome wheels, AIM 2" drop, Mobile1 w/FilterMag, clear corners
2000 E320, 1993 Cobra R, 1959 Corvette, 1949 Plymouth Coupe

Looking for a better paying job to support my L

Jim,

thanks.....just needed to dig a little deeper i guess.



[This message has been edited by Speedin Bob (edited 08-27-2000).]