Quick Time Pro's - what pressure?
 

I just got my Hoosier Quick Time Pro's mounted on some Weld rims. Sweet!

I was wondering what tire pressure people have been using at the track for the QTP's ??? :confused:

Going out to the track this Friday!! Hoping to see some big improvements in my 60' times.

I have found that anything less than 18 psi will make it "wiggle" down the track making it tough to stay straight in the lane.

hope u have a good set of traction bars and a drive shaft loop.

without both your gonan get in some bad trouble.

I got a Metco driveshaft loop but no traction bars

I run 16psi it dose get wild at the end of the track so be carful if you run 16psi.......

Personally I would NOT run sticky tires w/o something to the keep the axle from twisting.

At the very least put some clamps on the springs.

Rich