06+ Round foglight projector retrofit
#47
How did you trim the inner part of your shroud? I'm thinking a small cutting blade in my dremel... That's the only part that's holding me up. Well, that and ordering a new CCFL...
#48
I used small sanding drums on the dremel to trim down the inner part of the shrouds. You can be pretty precise with them.
#49
#50
Yeah I used a sanding drum and made 5 slots. 4 slots to go around the post brackets on the projectors, and one bigger slot for the highbeam relay. I think i'm going to sink the shroud deeper into the bowl.
And to cut the tabs to sink the shroud deeper I used a cutoff wheel like in the next picture.
And cutting the back small tabs.
.
And to cut the tabs to sink the shroud deeper I used a cutoff wheel like in the next picture.
And cutting the back small tabs.
.
Last edited by powerz69; 10-27-2011 at 10:54 PM.