I got my kit from TRS and I've read about the rotational adjustment mods and I don't think it can be done on my heads. I got the Stage III kit and the FX-R's are huge in the housing. I'm gonna have to order the Gatling Gun shrouds to cover the mounts on the FX-R. Was thinkin of painting my shield red to match truck but makes me nervous to take projector apart. Also I wanna make sure TRS sent me the right projectors as mine look much different than the ones shown in pics of Stage III kit on the site

 

You got the FXR 2.0 version. It has different mounting tabs and looks a bit different, but performance is nearly the same if not better than the FXR 1.0 version.

 

I started out the typical way of mounting them in the reflector bowl....then decided to go with rear mounting the projector and I'm MUCH happier with this. Here's a few rough bolt up pics. Nothing is sealed yet, just placed the headlight lense back on

 

Wow. That looks...different.

 

I think set further back like that it looks more OEM

 

Will it still fit back onto the truck with the projector set way back like that? I don't know if I would want the high beam solenoid exposed to the environment like that either, may want to try to seal it up or protect it.

 

I eyed it up and passenger side there's tons of room, driver's side looks good too but not as obvious