Does anybody have the Ford floor mats (either carpet or vinyl) with the Harley logo on them? How is the quality? Do they come with floor mats for the rear also?

Thanks

 

Hello Cobra;

I ordered the HD floor mats #5413086 for the front. No emblem available for rears. They look good in the accessory catalog.

When they come in will post a review.

Regards
Frank

 

Here is a picture of the Carpeted Floor mats. I have the rubber ones as well. The Carpeted driver mat tends to move around a bit. But they look great.

 

Try http://martinschon.net/photos/hd/BilletSill_Pass.JPG

 

i've got the rubber ones from pepboys with the diamond plate imprint, and the orange harley emblems on them for both the front and the back

 

Put the rubber logo mats in first, and then ordered the carpet front from the Ford dealer. They did not have the back in carpet. Did not care for the carpet(curled up on edges), so since I had given the rubber ones away, went to Pepboys & bought front & back rubber again. Like the looks of the ones that they have.

 

I have the rubber ones and I dont like them. They kinda look cheap to me. I really like the carpeted ones. they look cool, but I may stick with the rubber ones because they seem easier for me to clean.

 

I have both the carpeted as well as the rubber mats -- Use the rubber when it is messy out, but most of the time, all I use is the carpeted mats and am very pleased with them. They look very cool.

 

HarleyGuy:
Off topic, but your pic pretty much just sold me on the Altezza taillights

 

ShiftyBeeker, just fyi, i'm pretty sure those taillights aren't Altezza. They are from a 01 Lightning, just so ya know, mrtaillight.com has them for sale sometimes

 

thanks for the heads up 356.

 

ShiftyBeeker, get them. You will not be disappointed. They are about my favorite mod. I get a lot of reaction to the lights, too. People just cannot believe how great they look. It sets the truck off from all the other screws out there, as well.

Be sure to use shorter screws than the originals to install them. The install only takes about 10 or 15 minutes, but the screws need to be shorter or to have washers on them. I put the several washers on them to take up appx. 1/4" in their length and then used the originals. This isn't rocket science.