i'm about to get some pacesetter long tubes and i was wondering if anybody had any suggestions on special tools that might be usefull,like a good header wrench or just alot of patience.thanks for any help

 

an engine hoist-beer-cussing-and a lot of patience is what i hear. i believe that the cussing part is even in the instructions.

 

Don't know if the Pacesetters will fit the same as the Dynatechs but I ran across this awesome installation procedure a couple of days ago...it should help...

https://www.f150online.com/forums/sh...g+tube+headers

 

I installed my dynatechs from under the truck, it all went good. Had them both on in about 2 hours.

 

i was wonderin how they'd fit on a 4x4 seeing how they say they're only for 2x's it shouldn't be that hard i allready have my inner fenders out(i need to make some new ones someday) so there's a little room.i've got a cherry picker,a skid steer,2 tow motors,a wrecker,a backhoe,a forklift and possibly a bom truck all at my disposal so i should be able to handle it.i also have several bigass hammers(ford wrenches)

 

If you look at part number 72C2227, they are for 4x4's. For some reason, they arent on the pacesetter website under "products" but they're on 3rd party sites, and on the pacesetter price list.