I'm so frustrated! (rear seat removal)
Member
Joined: Jun 2005
Posts: 15
Likes: 0
if you are still having problems getting the seat clips to release, just take your other hand and hit the top of seat a few times. this seams to take a little pressure off of the clips and they open right up.
you can actually reach the clips from the sides of the seat. its tight, but you can squeeze your arm in the just enough to get a finger on the clips
you can actually reach the clips from the sides of the seat. its tight, but you can squeeze your arm in the just enough to get a finger on the clips
Senior Member
Joined: Nov 2006
Posts: 236
Likes: 0
From: lexington, ky
yes ,,,,,,it is a pain in the "you know what"!!!!!!!! i took a pry bar to push the bottom of the seat custion up so i could see the opening and the clips. and you do need to push down on the top of the rear seat and push on the clip. good luck!!!!!
Graphics Contributor
Joined: Sep 2006
Posts: 2,367
Likes: 0
From: Buffalo NY
Originally Posted by kelmvor
I found it easy, did it first time...here's what i do to take it off.
unfold the bottom seat half way...so it's at and angle and you can get your hand and a screw driver under the seat back. you have to put the screwdriver under the seat first, then slip your hand down there.
okay, now if you are looking back at the seatback, the slip needs to be PUSHED towards the bed to losen it. Now, at the left edge of the seat is what i will call the "structure". It's a metal bracket that runs up and down. Go to the right side of this bracket, put the head of the screwdriver against the metal as a guide and then slide it up till you hit resistance. Now pull on the bottom of the screwdriver and push up at the same time so as push the slip back towards teh bed and slide the screwdriver up into it at the same time.
now pull up on the seatback on that side and put something udnerneath so it doesn't fall back down when you do the other side.
enjoy!
unfold the bottom seat half way...so it's at and angle and you can get your hand and a screw driver under the seat back. you have to put the screwdriver under the seat first, then slip your hand down there.
okay, now if you are looking back at the seatback, the slip needs to be PUSHED towards the bed to losen it. Now, at the left edge of the seat is what i will call the "structure". It's a metal bracket that runs up and down. Go to the right side of this bracket, put the head of the screwdriver against the metal as a guide and then slide it up till you hit resistance. Now pull on the bottom of the screwdriver and push up at the same time so as push the slip back towards teh bed and slide the screwdriver up into it at the same time.
now pull up on the seatback on that side and put something udnerneath so it doesn't fall back down when you do the other side.
enjoy!
nice tutorial
but OFFTOPIC : DAYUM your truck is nice.
