so im about to redo my exhaust but been a lil busy to call up places as i have finals next week and its a little late to be calling haha.

Im just going to run straight pipes. So all i really need is the piping, and for it to be shaped to fit my truck. hoping someone can gimme a rough estimate. because my true duals with flow 40's and 4" chrome tips, and 2.5" tubing cost 580, so minus tips and mufflers doesnt seem to bad.

plan is to have dual pipes straight out the back, except right before the bumper they are going to angle 45 degrees down with black tips....kinda like the RBP exhausts, except duals, and by the bumper instead of under the cab.

 

you should just cut the mufflers out of your setup now and get them replaced with a piece of pipe. i had a single muffler flowmaster setup, si/do, and it cost 31 dollars to get it replaced with a piece of pipe. then get a shop to redo the tips how you're talking about it.

 

thats not a bad idea, but right now my exhaust comes out the corners of the bumpers, but i want them to go straight back now.

so id have to replace the muffler spots, and then cut the rear part of the exhaust at a certain point and put in new parts there to go straight back and angle down.

 

oh ok, yeah i wasn't sure where your tailpipes came out.

i would ask the shop about it. it may be cheaper to still do it that way. or you could just get all new pipes ran.

 

yeah may be cheaper that way but not sure, guess ill have to find out!

dpeending on total pricing i may keep my pipes out the corners and just put black tips on and weld in pipes in place of mufflers.....but i really like my new idea for exhaust