Hey all well..... i finally bent/broke something i need what i will call a transmisson cross member, do you think anyone makes one thats stronger than factory ford ?

 

A hit stout enough to bend the factory crossmember is probably gonna do a number on most anything you can fab/weld onto the truck.

Don't run over stuff in the future.

 

wow.. thats gonna cost a...

 

Just buy the factory piece. I'd rather have it bend than transfer all of the hit into the transmission and drivetrain.

It's actually not that expensive. I want to say it's a hundred or two hundred for the brace. I fawked mine all up on my 2004 F150. Lesson learned from that one ...

 

i will sell you 1, 90 bucks shipped!

 

Pics???

 

k, take em tomorrow

 

i have a bent engine cross member and oil pan

 

my truck has been in the shop for almost a month because of a crushed crossmember and cracked steering housing should get it back this week though

 

k who wants a crossmember i will send pics to your email

 

btw the trans cross member is about 20"x4"x2" right? long rectangle block, cause thats what i got

 

sorry guys ill post a pic when its not 107degrees outside.