My jumpseat has mounting brackets that go right down to the floor. I would think they would bolt into the same holes as your console. You would probably have to get a lap belt for it though. My seatbelt is fixed into the rear of the truck by the window. The bench does come with the buckel though, so all you would need is the strap.

 

I can check on how the seat belt mounts later today and let you know. Also the jump seat has a power outlet in the back of it as well. So that should just plug in when they are swapped.

 

Everything is the same. The mouting holes, the electrical outlet, everyting will match up. I swaped my jump seat for a XLT console earlier this year. The hardest part was to take out my jump seat, because I wasn't sure it the seat part of the jump seat came off, which it did and when it does it gives you access to the mounting screws and the electrical harness. I have a med flint jump seat as well if anyone is looking for one. I never used mine, therefore I just swaped it out with XLT center console. My Jump seat has been carefully packed in a box, ready to sell whenever I had the time. I can always sell it on ebay, right.

 

ill trade you

 

I am wanting the center console instead of my jump-seat
I have a black cloth interior.

 

Now that I am seeing how many people want to get rid of their jump seat idk if I want to trade. I would hardly ever need that seat but I was thinking it would be nice to have, but for how little I would use it, I might be better off keeping my console. What brough all this up along with my gear question is I want to take a camping trip but I would need six seats and lower gears to pull the camp trailer. After looking at what it would take to make this trip happen in my truck, I think I will just take my dads 350.

 

to me its kind of like you want it if you dont have it

 

Or you don't know what you want.