Picture 1: Tools needed... |
Picture 2: Headlight tab removal... |
T-20 Torx driver or 7mm socket, 1/4" ratchet, 6" extension |
Pull up on the 2 Tabs holding in the head light assembly. Gently remove the head light assembly and unplug it, Set aside... |
Picture 3: Removal of bolt holding the factory corner... |
Picture 4: Light plug removal... |
Use either a Torx T-20 or 7mm Socket and remove the bolt holding the factory corner lens. |
Pull out the factory corner lense and unplug the wiring. |
Picture 5: Bulb socket removal... |
Picture 6: Bulb socket install in Clear corner lens... |
Remove the bulb socket by twisting and pulling out. |
Insert the bulb socket into the new clear lense, making sure to twist until it locks in place. |
Picture 7: Plug install... |
Picture 8: Clear corner install... |
Take Clear lens and plug in the wiring from the truck. |
Slide the clear corner back into the factory housing... |
Picture 9: Re-install bolt... |
NO PICTURE |
Re-install the bolt by using the tool you selected. (Torx T-20 or 7mm Socket) |
Plug in the wiring to the headlamp, then re-install the headlight assembly to the factory housing. Make sure to take you time and note to insure prpoer line up of the alignment pins. Once you have lined up the pins, push in all the way until you can push down the tabs locking the headlight assembly to the housing. With this side complete, you may now repeat for the other side. |
Picture 11: Completed look... |
Here is a look with the Clear corners installed...Installation time is approximately 30 -45 minutes.......... |