Need 16x10" wheel pics on 01-03 Screw
#1
Need 16x10" wheel pics on 01-03 Screw
Not sure where to post but that's the pic i need.
Preferably on NON-LIFTED trucks please but either way for the sake of seeing the truck.
I'm not going to lift my truck and would like to see some wheel options.
I beleiev a member by the name of Chapman has some Eagle 187's on his and they look very nice
Anyone else out there...........
Preferably on NON-LIFTED trucks please but either way for the sake of seeing the truck.
I'm not going to lift my truck and would like to see some wheel options.
I beleiev a member by the name of Chapman has some Eagle 187's on his and they look very nice
Anyone else out there...........
#3
Thank ya sir!
Any adjustments to the torsion bars needed? Trimming of anything?
That looks just about what i'd like for my truck even though i was thinking of going with the 305's ...... i may just follow in your steps with the 285/75 set-up.
Got any rear shots to see how much they stick out? I actually prefer them to come out of the fenders a bit to make the stance look wider and not soo top heavy.
Any adjustments to the torsion bars needed? Trimming of anything?
That looks just about what i'd like for my truck even though i was thinking of going with the 305's ...... i may just follow in your steps with the 285/75 set-up.
Got any rear shots to see how much they stick out? I actually prefer them to come out of the fenders a bit to make the stance look wider and not soo top heavy.
Last edited by TRIXSNK; 01-02-2007 at 06:36 PM.
#4
You will have to trim about 1/2 inch of plastic off the front bumper's lower valance. I have pics of that as well as front shots showing how they stance is. Just click on the little camera icon to go to my gallary. Also, you are not gonna get the tires to stick out of the wheelwells unless you go to a 12 inch wide wheel. My tire/wheel is just about perfectly flush with the edge of my fender flares up front.