Engine Rebuild(best Cams)

[Stephen87]

As the title says I am going to rebuild my 4.6l engine(I am not gonna do the 5.4 swap because if I did that and want to make it forged it would be twice as much) and eventually(read: maybe one day) slap a small turbo on it so I guess my question is what would be a good set of cams that would be affordable and best for low-end torque. I ask for low end because I dont really want a speed demon I would rather have something with a good amount of torque that I can pull my project car around with(a 1974 corvette stingray) also assuming I get to actually put a turbo on the engine would the m5OD handle it and also would I still be able to put the turbo on with the PI heads or would the compression be too high

Register today or sign-in to remove these ads!

[shifty_85]

built 54 found me some when i was looking. Comp cam extreme engery 1,000rpm-6,000rpm 262 intake 262 exhuast .54 duration or somthin like that.

stock cams are set up like 3,000-6,000 RPM its horible Trition turbos is what i call the triton motors.

good luck.

[built54]

Id say any stage II cam would help you out.

[Stephen87]

OK well this is what I found, what do y'all think

http://www.summitracing.com/parts/CCA-102100/