Starter problems...
#1
Starter problems...
Okay, so I've been battling this starter problem for a while... it seems that the positive side on the starter keeps coming loose... i can barely reach the top side of the starter to tighten on it good or put any kind of thread lock on it... how hard is it to remove the starter and work on it from outside the vehicle? Also, I am going to re-run the hot and ground from the battery to the starter.... whats that little wire by the positive side for?
Daniel
Daniel
#2
#5
#6
I'm pretty careful and I broke off the top bolt trying to get the starter off my '97 4.2L manual transmission. Even though just the cap broke off the bolt, and I smacked it pretty good and heated around it and then cooled the bolt itself, the bolt broke again. Thought it was just bad luck, but the used transmission I put back in it had a broken off bolt in the same place. Bottom line, it can be tougher than it should be to remove a starter.