mazda m5od can kiss my tail pipe

[will54768]

ok 93 f150 mazda m50d. well just got it from a friend he had a new clutch, throughout berrings, and presure plate installed. when i got it it would only go into 2nd and 4the, so i rebuilt the shifter assembly since the bushings were gone. well now it gos nowhere . u can put it into gears only if the ingine is off. if u leave it in gear then crank the engine its ok and u can releas the clutch and drive in that gear. also if u put it into reverse and crank it it kicks out of gear as soon as u release the clutch. it has puzzled me. there is steady preasure on the clutch pedal and the fluid level is fine in the clutch resevoir. please help this is bugging me. thank u in advance guys

Register today or sign-in to remove these ads!

[Guitar_Stitch]

Maybe it wasn't bled?

[will54768]

thats what im guessing ill try to bleed it, correct me if im wrong its brakefluid huh, and im not 100% sure where the bleeder screw is il look but u got a hint , lol

[Memphis_Chief]

System takes DOT3 brake fluid. And the bleed screw is accessed through a hole in the bell housing(driver side). It may have a rubber plug covering the hole. The screw is brass and is just below the line going into the slave cylinder. I'd plug a small vinyl tube into the hole on the bleed screw to train the fluid into a pan or something.