mudder fn flapers

[5.4MAN]

hey i gots a ider i gotes dis big azzzz gap inbetween my frame/front wheel's and du wheel well cover so how about goen to pick and pull wack off some of that rubber splsh gurds and trim to fit to cover dis up so water and mud dont a go flyen on my new headers hu?? or will i tin to heat things up like a hot alibami sumeer????

Register today or sign-in to remove these ads!

[5.4MAN]

ya know what i just posted dis in du wrong section ! what du heelll dis got to do width du tranny !@!@ sorry about that

[wolf_creek_61]

i believe i speak for the whole site when i say huh? what the hell did you just say?

[5.4MAN]

thats one bad azz truck!!!
what you got for slash protection???

[5.4MAN]

wut a moment that (splash protection from mud and water have you done any mods yoreself??

[5.4MAN]

hey man i want a crome bumbrer like youres will that fit on a 99 f150 flare side 5.4liter cuzzztem exsat strate pipes no cats /micro tuner super chip/ cool air bm shift kit high stall tire smoken rachet shiften 325 hp dyno proven 5.4liter _V8_



hehehehhehehhhhehe soundid good hu some day but so far got the headres and exsate(did i speel dat right?)

[wolf_creek_61]

proper english please and i may be able to help you

[powerstroke73]

Huked on fonics wurked 4 me!!!



Go back to English class before you bother going online again. So far nobody has been able to understand a single noise (can't call them words) that has come out of your mouth.

[buckdropper]

I believe that is ebonics not hooked on phonics. dasmen putes mes ups ones frontes streets maofo. Sir please type in english using proper wording, spacing,verbs,nouns etc.. and we may be able to address your question with properly placed wording. Your attention to detail in your wording leaves me at a severe disadvantage to address any of your concerns.

[5.4MAN]

ok maaaan sorry about the worden but i was just trying to be a smart ass towards bman for dissen me about a word i mispelled a time ago.....so it's like this .I got some new headers on my 99 f150 flareside 5.4l 4/4 off road one day i seen a big mud hole and flew thru it and massive steam was coming off my headers i was afraid i might crack them. so my Q is can i add more flaps or splash guards to my truck with out heating my engine compartment up.the place i thought would be good for placing them would be / take a look a youres /front wheel well inbetween the well and frame you know that place where you can see the headers?? i know this is the tranny thread so does any one know what tranny i got ??yes i have looked at the tranny id noten to faded and the engine id nothen and the door id nothen it can only be three of them the 100,Od.or the ow tranny???

[wolf_creek_61]

try this

[5.4MAN]

THANK YOU THAT HELPS ALOT.
DO YOU HAVE ANY OTHER IDEAS LIKE A FRONT DIFF./ TRANNY SKID PLATE BECAUSE MY TRUCK DOES NOT HAVE ANY IN THESE AREAS.

[wolf_creek_61]

after a quick search i didnt finad any tranny skid plates for our trucks and the only diff sidplates ive seen were for a ford 8.8 diff
but yo can get bull bars and brushguards with skid plates on them im not sure how much that ill help ya though