Finally decided to go lower.
#1
Finally decided to go lower.
So far I have installed 2" lower springs in front and had alignment. Next is the rear. I was thinking 2" rear shackles or flip kit by DJM. But it dawned on me. I have an extra 9.75 fully built laying around. Why dont I just flip the bracket that the leaf bolts too.
#2
#3
#6
Assuming you are going to tack in place while somewhat assembled in the truck I would set it up for the right pinion angle. If it is a one piece driveshaft you just need to set the angle of the input shaft equal but opposite of the tail shaft on the transmission. You may want to preset it with +1 degree for axle wrap under acceleration.