Is there still intrest in doing this on the 18th before the Hooters get together.

If so lets get some plans set. Im intrested in going, pretty much just as a recovery vehicle.

Im not familar with the area as good, so someone will have to set a meeting place and wheeling place.

 

I am definitely up for some wheeling, but also am unfamiliar with the area. Who else is interested.

 

There is Rancho between Lakeland and Zephyrhills, about 20 mins or so from Hooters

 

yeah Rancho would work, i didnt think it was that close to hooters though.

 

Its a straight shot, take a right on Highway 98, go straight for about 20 minutes depends on how heavy your foot is. I cant make it, I gotta work till 4, but I will be at hooters at 5

 

Ok where is rancho? Sounds like here or so from reading descriptions and looking at Google maps. Sorry for being unfamiliar. A quick Google didn't reveal much on "rancho".

http://maps.google.com/maps?f=d&sour...17294&t=h&z=11

 

its about 20 minutes from lakeland, and i'm pretty sure its right before dade city, I know when your going down 98 heading north, its a little bit after where you would normally turn to go through webster and terrytown

 

If you look at the map, you see rockridge on the right, that road meets in the middle of 98, you go past that for about 10 to 15 minutes

 

Crap, I also work til 4 and will be at Hooters a little bit after 5. Did do a little splashing around last night though. Got your PM Cecil,,sorry, I gotta wash it, can't show up dirty. Haaaaa.

 

I'm down, I'm definitely going to need the recovery vehicle lol. My tires are about shot and have next to no tread on them, but that's not stopping me from getting the truck a little dirty. I'm not familiar with that area at all, so if everybody wanted to meet up somewhere where I can punch an address into the gps beforehand, that'd be cool.

 

At least you have real tires. I have some sweet hancrap OEM look-a-likes. So tiny too, 265/70-18. They just aren't cutting it.

 

yall could go to richloam out of US 471 before webster, its a little further than rancho from hooters but theres some real good holes out there on the west boundary line and the powerline

 

guys not looking good for my truck for the offroading or G2G. Unless i can fix my steering knuckle before the meet.

i broke some welds (just driving no offroading or anything) and need a torch to properly weld them back. however i do not have a torch so this task would be kinda hard.

if anyone knows someone that can weld cast steel then send them my way. I dont have alot of money to spend so tryin to find someone that wont hose me. its only a few inches of welds needed.

really all i need is a brazing torch i have a welder. Need to get the cast RED hot so i can weld some copper rods to it... if anyone has a good brazing welder let me know maybe we can meet at my shop and knock it out before leaving.

even if i dont fix my truck i do have a spare vehicle so i will make it to the G2G at hooters

 

So are we meeting somewhere before to wheel still or no? Either way let me know, I will check back here in the morning. If anyone feels the need to call my number is 239-410-8151 (Kyle).