panda24619

Yea I am headed to pismo today. Yea I would just watch the leak. The dealership just puts rtv there to seal it. It might leave when you get the tranny down to the normal level and not overfilled. I am down for a trip to pismo later. would be better in september. I am gonna be out of the state the last 2.5 weeks of august.

Oh yea you shouldn't have to pull the pan. I know that there is a pump you should be able to find that has a hose on it and you stick it down the fill tube, or just pull the pan plug for a little bit until you get it low enough. Just a couple ideas.

Well the 6 speed should be easier in yours cause you don't have torsion bars do you?? Nice. I am trying to sell my edge/gryphon. Plugged it in but never used it. Haha Going a completely different way and trying the self tuning. Since I am going with an L setup.

Yea they could be it. They act up when they are too full. Hope it's nothing major! You get a programmer yet??

Hey man. Yea just trying to figure out the route I wanna go with my set up right now. Would love to do long travel or SAS but don't have the money for that. So deciding if I wanna lift more or make a custom crossmember for the torsion bars. Yea man I will definitely help you out too if you wanna go the same route. Once I figure out how I'm gonna go I'll start updating 6 speed swap thread.

if you ever get a trip going let me know, im always down for doing some wheeling

I apprerciate the photo, but it's not quite a match.

did your trip out to truck heaven ever happen? any other trips going on in the near future?

Thank's for your vote for TOTM.

Are you ready for this? Post here http://www.f150online.com/forums/wes...-road-fun.html