BRIV59

im not sure. i think its the plastic one. its whatever they were selling on roush overstock.

Yea i had 37'' kumho mts on 24x10 kmc xd monsters. The wheels and tires cost me around 4600. It was just a body lift that i had at first and they fit but only because the wheel offset was positve, +5 i believe.

yes! i actually have the sub box pulled out from the back so that I could lift the seat up and show it. when it is puched all the way against the back wall the seat is down and unable to lift up.

ReSurface (sand blasting) and poweder coat was $250 even on the Saleen wheels.

Brah! duh! i know that's a sa xd 45 acp, it's mine. i told that clueless *******ing CRAZYREDNECK it's not a damm glock!!!

Its a single turbo setup. Right now I have 468 rwhp on 12 pounds of boost. But I also have a built short block and a twin hat JDM fuel system with 39 # injectors

theyre not too big, you just have to sacrifice. go check out my cardomain to see my 1st setup with one w7. it all depends on how much bass you want. all three of my setups sacrificed something. 1st one = one passenger seat. 2nd one = back seat comfort. 3rd one = bed space

Well if you are adding a Roush charger then Id hold off on the pulley's I dont know how it would effect your boost production but Im sure you could find out though just to be on the safe side keep your stock pulleys and just see the difference for yourself. But it sounds like you are headed in the right direction and the bullit theme on a F150 would look sick good luck with everything and if I can be of any help just ask

What mods do you have currently

Thanks brother I put both mods on the same day the E-fans and underdrive pulleys so I freed up quite a bit of horsepower but I could tell a difference in the low end of the truck and the throttle response is alot better I dont know how much horsepower exactly it freed up but I could definitely tell a difference