NitroNewfie

I have a T-Rex grille that I did install....

you have an RBP grille your trying to install?

Thanks bud! Just ordered mine!

Hey, just noticed your message...yep the holes line up perfectly on the '05. I love these badges. They are the best looking and the CHEAPEST mod so far! The hardest part about the installation was the removal of the old doublesided tape. I used some WD40 and an old credit card. Start by peeling the largest patch you can hang onto, then using the credit card, slowly start pushing back where the tape meets the fender while pulling the tape back. The credit card will act like a scraper of sorts and helps the tape seperate from the truck. The WD40 helps to break down the glue as well.

My 35's cleared fine because I had stock wheels with the 2.5" leveling kit. I would stay with 33's if you're going to run those 7105 wheels with just a leveling kit because if you had 35's (with just a leveling kit) you'd more than likely rub fairly bad. Stick with stock wheels if you want 35's with just a leveling kit

Thanks man, I believe the 7105's have the same specs as my 7005's, 18x9 with 5" of backspacing

Thanks DanF150! I have a 2.5" leveling kit now just to get a set of 305's and wheels.

yes i have the 2.5" leveling kit, my 305's do not rub at all...not even at full lock. But i did have to trim the front bumpers lower valance a little bit. Other than that it's golden.

Yep, just a 2.5 Daystar kit...