ibcop

In reference to the 09' .pdf exploded center console view and/or how to remove center console trim instructions.

tecc77@yahoo.com

Thanks in advance!

the truck has no nav, nor does it have the center console. the shifter is on the steering column, and there is a 3rd bench seat. if need be I can send a picture of the dash to you.

hey there,

I understand you have instructions on removing the radio / center dash piece on the 2009 F-150, can you possibly send me those instructions? I would really appreciate it. you can pm them on here, or send them to fred@rockstar69.com Thanks!

Thanks much.

Hey there ibcop, Thanks for the offer on the 09 door panel removal. I'd like to take you up on those instructions if you can get them into a sendable format. Just a little hesitant to start tearing into it with the little info I have.

Thanks for the info!

PDX-5 wire gauge
Here are the power specs for the PDX-5.

RMS Power Ratings
Per channel into 4 Ohms: (@ 14.4V Ƈ%THD+N, 20Hz - 20kHz @ 4I? for 4ch.) 75W x 4
Per channel into 2 Ohms: (@ 14.4V Ƈ%THD+N, 20Hz - 200Hz @ 2I? for Mono ch.) 300W x 1

As far as the gauge to use for power & ground 4 gauge is a bit of over kill. That size is used for systems that generate 1520 to 1800 Watts RMS. That's equivalent to a draw of 106-125A. That is for a length of up to 10 feet. Since that amp will be drawing 600 Watts RMS a 8 gauge will do just fine and have more than enough head room since it will handle 725-935 Watts RMS for up to 7 feet, for 8 to 10 feet go with 6 gauge. This info comes from
Alpine's Mobile Media Solutions for 2009.

Nope, it is factory. All I did was level the front end and put some tint on the windows. Granted, I figured if I was going to go in debt, I was going to go in debt good and got every option I could. Thanks for the compliment!

Wow nice looking truck. Is it stock from the factory, or did you do some upgrades?

NO, I decided to find an FX4 with the camera already factory installed. I couldn"t get a firm aswer from my dealer as to whether or not the wiring was there already as they didn't have any units without the camera. Have you found anything?