Duraliner dividers

[jhorie]

This is my first bedliner. OK, as my wife points out, it's her truck and her bedliner. 2000 F-150 Lariat Supercab shortbed, 4X4, Tow Pkg, Duraliner bed liner. Being the good husband that I am, I am cutting some 2 X 6 divder boards to fit in the built-in slots in the liner. There is one set of slots that hold a board vertically (6 inch side up and down). It was about 64 inches and fit OK. But... there are sets of slots to hold three boards horozontally, 68 inches long. I cut a board to fit, but can't fit it. Too long to get past either the bed rail or other contours of the bed liner. Can anyone with a Duraliner help?
I'm clueless.

Joel


[This message has been edited by jhorie (edited 03-16-2000).]

[Indyfan]

Actually I used 2x4s to make the "shelf", I don't remember what size I cut them to but I do remember bringing them in at a wierd angle just to get them into the slots.
Try bringing it in diagonally to the bed until you get under the bedrails then spin it so it's perpendicular again; but do the last step real close to the level of the slots, not right under the bedrails.

------------------
1999 Lariat Super Cab, S.B. 5.4L, 3.55 LS
and everything but the leaky slider window.
Bright red w/ gold 2-tone, Leather Captain's Chairs
Mods: Duraliner bedliner, Bugflector II, Hide-a-hooks.
& a leeetle chrome tip on the exhaust.




[This message has been edited by Indyfan (edited 03-16-2000).]

[jhorie]

Indyfan: Thanks. I tried putting them in diagonally, but no luck. I think I'll give it a try with 2X4s, like you did, to see if that's the trick.

Joel