Duraliner dividers
This is my first bedliner. OK, as my wife points out, it's her truck and her bedliner. 2000 F-150 Lariat Supercab shortbed, 4X4, Tow Pkg, Duraliner bed liner. Being the good husband that I am, I am cutting some 2 X 6 divder boards to fit in the built-in slots in the liner. There is one set of slots that hold a board vertically (6 inch side up and down). It was about 64 inches and fit OK. But... there are sets of slots to hold three boards horozontally, 68 inches long. I cut a board to fit, but can't fit it. Too long to get past either the bed rail or other contours of the bed liner. Can anyone with a Duraliner help?
I'm clueless.
Joel
[This message has been edited by jhorie (edited 03-16-2000).]
|