|
they are holding up great, no i did not tape them off. just sanded with a 600 grit foam sanding block and wiped everything down with the "prep all" stuff i mentioned earlier. I also painted the plastic piece just inside the door. It is also holding up well. take my advice though, let it dry for like a week before putting it back in the truck, i did not wait and had to repaint it. at 10$ a can mistakes arent cheap. Ill try to get a shot of my bed for you all tomorrow. Doing you bed with this stuff wont hold up to lumber and 4 wheelers very well, but if you dont use your bed often for that stuff it should be ok. Even with two coats (15 cans) its still a little bit thin for my taste. But i aslo have a bed mat in it...
Krylon fusion will not hold up to much, if any, traffic. but it works well for dashboards and door trim.
|