Thanks Greg! I tackled this today and your instructions were fantastic!
I have a 2000 Supercab 2 wheel drive Lariat and I don't know why, but step 3 (steering column cover) was different. I had 3 screws holding the 2 halves together, not the 4 clips like you have. Took me a minute to figure that one out
. I also had to remove the lock tumbler in order to remove the top cover.
When I was removing the back cover off the instrument panel I was using a 7/32 socket and a few of the screws weren't accessible with it (socket diameter to large). Fortunately, I had a T15 Torx driver that worked. If someone is going to tackle this project, you might want to have one of those on-hand just in-case.
I would also suggest that you use a nut driver instead of a rachet when removing the dash screws. It made things go quite a bit easier once I did that.
Ford did a pretty good job making all these panels easy to remove and install without breaking anything.
Again Greg, thanks for the great post.