Step Six
Using the 18mm deep socket, remove the nut on the underside of the sway bar.
Step Seven
Remove the lower strut bolt using the 30mm socket on the nut end and the 1 1/16” wrench on the bolt end. A note on this nut and bolt…..it is a bear to break loose, so if you’re not strong enough, go grab a buddy that is. I’m not kidding. I'm a hoss, so it was not a problem for me hehe.
Step Eight
Remove the three upper strut nuts using the 15mm socket.
Step Nine
Loosen, but do not remove the nut on the ball joint bolt with the 21mm deep socket.
