Does anybody know the torque specs for installing upper and lower control arms?

 

upper c arm bolts 84-112 ft lb
lower arm nuts 121-148
lower ball joint nut 83-112
upper ball joint nut 57-76
tie rod end nut 57-76 ft lb
as per ford service manual

 

Thank you sir!

 

I know this is an old thread but chalk up another win for the search function!

 

Great thank you very much! do you know what the axle nut torque is?

 

You mean the spindle nut on the front hubs? No specific torque, tighten it while spinning the rotor as tight as you can get it with a 3/8" drive ratchet, then stop spinning the rotor, back it off 1/4 turn, then finger tighten it. Put the retainer on with the cotter pin holes lined up and insert a new cotter pin.